Jump to content

Moving start and stop beads

Featured Replies

Posted

I've gone blank.  How do I move the start and stop beads once they are set in a embroidery design?  I was digitizing an outline around a letter and want to move the start and end points to a different side.  I know there is a way, I've just forgotten and can't find it in my notes.


 Make sure the part is selected, and your beads are on/displayed. Put your curse on the bead, left click and drag to where you want it.


 Usually only the ARROW cursor can move the begin and end beads. Make sure the segment is a closed segment or else the bead may not move to where you think is ok.


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...