Jump to content

Eunny extra embroidery stitches

Featured Replies

Posted

I have had a embroidery design digitized but when I open it, it says 117 mm but should be 60 mm. and when I take the 3D off there is a funny stitch way out the the side. I am new to this and do not understand what it is or how to get rid of it?? there is like a traffic light symbol there to?


The Traffic Light symbol shows you the over all design Start / End Point location. Did you place it where it is right now?


In any case, if you have digitized this design then you do have the EMB file and you can easily change the Start / End Point location by clicking on the Set Design Start / End Point Tool:


You will see a dialog appearing where you have various choices.


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...