Jump to content

Embroidery design not realigning after bobbin change


Recommended Posts

Hi,

i have this annoying issue with my brother v3.  when embroiding a big design that requires a bobbin change during it comes out of allign with the pattern when restarting.

So after changing the bobbin and starting again the needle will be stitching over areas it shouldnt an missing out areas it should. So would be a  few mms above or below were it should be stitching.

ive tried turning it off an on an letting it reallign but it just starts at the same place again. Ive tried restarting the design an moving it futher down to make the difference up but still hasnt worked

any ideas what the issue is anyone?

  • Like 1
Link to comment
Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...