hi there,
is there a standard density satin stitched lettering should have when going over the top of a complex fill stitch?
when i do say 5-6mm lettering on top of a complex fill, i usually have the density at -.5 to -.6, with the pull comp at approx .12 to .15 - it normally comes out looking great, except where the stain stitch letters have the same angle as the complex fill, causing the lettering to fall away and get lost in the complex fill.making these letters look thinner than the rest.
and should there be an underlay on small text when going onto of a complex fill stitch??
i normally use a single line underlay stitch at approx length of 1. to 1.5.
can anyone out there help, this is lettering our digitizing and quality down
your help would be greatly appreciated
thanks