Kratzer Posted 19 hours ago Share Posted 19 hours ago Can I send designs to the designs from computer with windows 11to the Janome MC10000? Quote Link to comment
diver361 Posted 3 hours ago Share Posted 3 hours ago Transferring embroidery designs from a Windows 11 computer to the Janome Memory Craft 10000 (MC10000) presents compatibility challenges due to the machine's age and its communication limitations with modern operating systems. The MC10000 was designed to interface directly via USB with older Windows versions, specifically Windows 7 32-bit and earlier. It cannot communicate directly with 64-bit systems, including Windows 11. To transfer designs, you can use a Compact Flash (CF) card with a PC card adapter. Obtain Compatible Hardware: Compact Flash Card: Use a CF card with a capacity of 512 MB or less, as larger capacities may not be recognized by the MC10000. PC Card Adapter: This adapter allows the CF card to interface with the MC10000's PC card slot. CF Card Reader for Your Computer: If your computer lacks a built-in CF card slot, a USB CF card reader will enable you to read and write data to the CF card. Format the CF Card: On Your Computer: Insert the CF card into your computer via the CF card reader. Open 'This PC' or 'My Computer', right-click the CF card drive, and select 'Format'. Choose the 'FAT' file system (avoid 'FAT32'), check 'Quick Format', and click 'Start'. On the MC10000: Insert the formatted CF card into the PC card adapter, then insert it into the MC10000. Navigate to the 'Set' mode on the machine. Scroll to the option for formatting the ATA card and confirm. This action creates the necessary folder structure on the card. Transfer Designs to the CF Card: Connect the CF card (in the card reader) to your computer. Locate your embroidery design files (.jef format) on your computer. Copy the desired designs into the appropriate folder on the CF card. For the MC10000, place designs directly into the 'PC_Link' folder. Load Designs into the MC10000: Insert the CF card (with adapter) into the MC10000. Access the 'Open Mode' on the machine. Select 'ATA PC Card' as the source. Navigate to the 'PC_Link' folder to locate and select your design for embroidery. By following these steps, you can effectively transfer embroidery designs from your Windows 11 computer to your Janome MC10000. This method circumvents the direct USB communication limitations posed by modern operating systems. Quote Link to comment
Kratzer Posted 1 hour ago Author Share Posted 1 hour ago Thank you so much for your help! Quote Link to comment
Recommended Posts
You can post now and register later. If you have an account, sign in now to post with your account.