Shellie Posted February 4, 2014 Share Posted February 4, 2014 Hello community, I am having a problem with the thread coming out of the needle at the beginning of the run and between trims. The thread seems to be bunching up and eventually comes out of the needle. Any suggestions? Quote Link to comment
Gerry Posted February 4, 2014 Share Posted February 4, 2014 If the thread is frayed and bunching up on only one needle, you may have a bur on the needle and it should be replaced. If it's happening on all your needles, it may be your tail is too short and you need to adjust your machine settings. On the Neo II, select Machine Settings, then down to Trim Length. Use the left/right arrow to change the number. Quote Link to comment
Recommended Posts
You can post now and register later. If you have an account, sign in now to post with your account.