whancox84 0 Posted November 11, 2018 Share Posted November 11, 2018 Hello, I have a Brother VR and love it but i have recently been downloading free designs from internet and as some of the designs are too big i resize with wilcom (free edition) but when I make the design the stitch count is so high that it basically cuts the design out of the t shirt and you can see big holes around the design. I have used Buzzsize to adjust the size and stitch count but now it misses inner parts of the design out. Any advise would be amazing as I have been told to buy PE Design 10 at £999 which will sort this out but I cannot afford it. Are there any other pieces of software i can use or if there somewhere else i can get my designs. I have attached photos, the red flower is the lower stitch count, the green and red flower is the original design. Thanks Wayne Quote Link to comment https://forum.embroideres.com/forums/topic/3502-help-new-to-embroidery-problems-with-stitch-count/
krso 4 Posted November 12, 2018 Share Posted November 12, 2018 You can try Wings My editor to reduce your stitch count. That one is also free or Hatch by WIlcom. They have a free 30 day trial of the full software. On 11/11/2018 at 8:28 AM, whancox84 said: Hello, I have a Brother VR and love it but i have recently been downloading free designs from internet and as some of the designs are too big i resize with wilcom (free edition) but when I make the design the stitch count is so high that it basically cuts the design out of the t shirt and you can see big holes around the design. I have used Buzzsize to adjust the size and stitch count but now it misses inner parts of the design out. Any advise would be amazing as I have been told to buy PE Design 10 at £999 which will sort this out but I cannot afford it. Are there any other pieces of software i can use or if there somewhere else i can get my designs. I have attached photos, the red flower is the lower stitch count, the green and red flower is the original design. Thanks Wayne Quote Link to comment https://forum.embroideres.com/forums/topic/3502-help-new-to-embroidery-problems-with-stitch-count/#findComment-11422
nanato9 7 Posted November 14, 2018 Share Posted November 14, 2018 Hi Wayne, I also have several of the "free" software, those can only do so much. I have been looking into the Embrilliance line. It has several parts to it but they are very much affordable and if there are parts you don't want you don't have to purchase them. I belong to several FB sites and everyone uses different software however I haven't heard anything negative about this line.. Hope this helps.... Nana to 9 1 Quote Link to comment https://forum.embroideres.com/forums/topic/3502-help-new-to-embroidery-problems-with-stitch-count/#findComment-11425
nanato9 7 Posted November 14, 2018 Share Posted November 14, 2018 Wayne, also I have a Brother Innovis 2800 and they told me also to get the PE I believe it is all about money with them and they are over rated from what I'm told. Here in the US they want 1500.00 dollars I'm not that rich...Lol Good Luck.. 1 Quote Link to comment https://forum.embroideres.com/forums/topic/3502-help-new-to-embroidery-problems-with-stitch-count/#findComment-11426
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.